If you’re planning to knock through a wall, widen a doorway, or open up a kitchen-diner anywhere from Chiswell Green to Welwyn Garden City, at some point someone will ask you for structural drawings and calculations.
It’s one of those phrases that gets thrown around by builders, architects and Building Control officers alike, often without much explanation of what it actually means. If you’re carrying out internal structural alterations, here’s what you need to know.
What Are Structural Calculations?
Structural calculations are the engineering workings-out that prove a proposed change won’t compromise the building.
If you’re removing a wall, the calculations show:
• How much load that wall was carrying
• What size steel beam or lintel is needed to replace it
• How that new beam transfers its load down into the walls and foundations either side
• What padstones or pattress plates are needed to spread the load at each end of the beam, so it doesn’t crush into a wall that can’t take the point load
These calculations aren’t based on guesswork or rules of thumb. Instead, they’re produced using the specific spans, loads, and materials involved, and they need to be signed off by a qualified structural engineer.
What Are Structural Drawings?
Structural drawings are the visual companion to those calculations. They show, on a plan and often in section:
• Exactly where the new beam sits
• Its size and type
• What it’s built into
• Any other structural elements, like new studwork, joist hangers, or steel columns holding it up
Together, the structural drawings and calculations form the package Building Control needs to approve the work and your builder needs to carry it out correctly.
Why Structural Drawings and Calculations Matter for Internal Alterations
It’s easy to assume a wall is “just a partition” when it may actually be carrying floor joists above or providing the lateral restraint that keeps other walls stable.
This is especially true in the older Victorian and Edwardian terraces around St Albans and Watford, where internal walls were sometimes built thicker and load-bearing in ways that aren’t obvious until you check.
When You’ll Need Structural Drawings and Calculations
Common scenarios include:
• Removing a chimney breast
• Opening up a wall between two reception rooms
• Creating a wider opening between the kitchen and dining room
• Removing a wall to install a steel beam for open-plan living
• Enlarging a doorway, if the wall is load-bearing
How the Process Works
1. Site visit — the engineer inspects the existing construction, assesses loads, and checks for anything unusual, such as old cracks, previous alterations, or unusual spans
2. Calculations produced and drawings issued
3. Submission to Building Control alongside your Building Notice or Full Plans application
4. Construction — your builder works to the exact drawings
5. Inspection — Building Control typically checks the beam installation before it’s covered up
Speak to a Structural Engineer Before You Start
Building Control can, and will, ask for retrospective calculations if none exist, which often means opening up finished work to check it.
Getting it right first time keeps the project moving and gives you a proper paper trail if you ever sell your home.
If you’re planning internal structural alterations, speak to a structural engineer in Hertfordshire before work begins. Get in touch with Hertfordshire Structural Engineers today to arrange your structural drawings and calculations before work begins. We’ll make sure your alterations are safe, compliant, and supported by the engineering documents your builder and Building Control need.


